![mk4 tdi boost gauge kit mk4 tdi boost gauge kit](https://i.ytimg.com/vi/RgsCy2V6ysU/maxresdefault.jpg)
P3Cars Vent Integrated Digital Interface for Mk4 Jetta Golf TDI.
#Mk4 tdi boost gauge kit install#
Easy install with great looks, put boost gauge on.
![mk4 tdi boost gauge kit mk4 tdi boost gauge kit](https://www.egr-delete.co.uk/wp-content/uploads/2017/01/57mm-vw-removal-kit.jpg)
Volkswagen MKVI Angled Vent Pod Gauge Kit. Find great deals on eBay for jetta boost gauge jetta gauge pod. 1999.5 VW Jetta TDI Bosch.216mm injectors and Malone stage 2. For ground use the body panel clip and screw to secure ground wire to dash metal frame.Īuthor Topic: MK4 Boost Gauge install (Read 3516 times) February 28, 2011, 05:19:45 pm. If you do not have a W8 panel tap at dimmer switch (Grey and Blue wire). If you have a W8 panel, use a three way connector to tap into the dimmer wire. NOTE: Doing it this way will leave two holes on A pillar that will be noticeable if the POD is removed.įeed wires for light socket through one of the holes previously drilled. We found it to be easier to drill the A pillar so that the tubing and wiring can be feed through. We used duct tape to secure pod to pillar, however there are different ways of doing this, glue is another way. Route hose through the bottom of the A pillar opening.
![mk4 tdi boost gauge kit mk4 tdi boost gauge kit](https://c1552172.ssl.cf0.rackcdn.com/236345_x800.jpg)
Route hose under dash through opening above fuse panel. Remove lower kick panel and under dash panels. Remove fuse panel cover pulling on the bottom corner. TIP: Make sure that your hands are clean. Remove A pillar applying pulling pressure at the top left corner. Install the engine covers back reversing the order that they were taken apart. Use the grommet located on the firewall to the right of the brake booster to insert tubing inside the car. Make sure that tube is not rubbing or touching any engine parts that can become hot. Once all hoses are connected it should look like this: Route tubing through engine compartment. TIP: Use heat gun on the tubing to make it easy to insert into T connector. Squeeze the clamp using the wire cutters. Re- route hose in original position and connect it to pressure regulator. TIP: Use Soap on the T connector to make it go in easier. Make sure that you connect the original hose on both ends of the T, not in the middle.
#Mk4 tdi boost gauge kit driver#
Part one (Engine)Remove Engine Cover using Philips or flat head screw driver (4 in total for top cover)Remove lower Engine Cover using the same procedure as above. You will also need Hardware (provided with KIT with the exception of the body clip and screw and car ). Drill (Optional), wire stripers, crimping tool, duct tape, flat and Phillips screwdriver, Torx socket or bit, heat gun and needle nose pliers. To get started, you are going to need tools. We are not responsible for any damaged caused by using this DIY. DO NOT INSTALL THIS POD WITH SIDE CURTAIN AIRBAGSDo it at your own risk. With some patience, and the right tools it was an easy job.